4mm & 7mm Llanfair ....

[NHY 581]

I'll get mine in early........


Welcome back to 00, Larry....

Rob.

 

[LarryG]

I'll get mine in early........


Welcome back to 00, Larry....

Haha, I've sold all the '00'.

 

[PaxtonP4]

Haha, I've sold all the '00'.

I think he was referring to when you buy it all back again.

 

[paulc]

I'll get mine in early........


Welcome back to 00, Larry....

Rob.

Ouch!!!

 

[Osgood]

 

[LarryG]

The goods shed was too big, so I worked out how much could be removed from the width without it looking too obvious. 10mm out of the doorway plus 15mm out of the end wall should do the trick, so I set too on yet another kit....




I always had a preference for a blank wall...


Quite a saving to allow the signalman a reasonable view down the line.....


Still no room for a lorry behind the shed....It's all kidology! I'll complete the shed now.....

 

[Muddysblues]

Good luck with this one Larry

Craig

 

[LarryG]

Holding a roof down while the glue sets.....



The sliding door was attached temporarily for photos....


Doors suspended by brass wire pushed into holes. A new office added .....

 

[LarryG]

With being mainly a desk modeller, the layout is coming on very slowly. Lack of space for a wide baseboard has restricted things a bit, but a small gap behind the primer-painted goods shed looks better than that structure pushed up against the backscene...



Pieces of timber and a coach have helped me to visualise things and determine the run-round length. I'm leaving space beyond the crossover for a small tender loco.....